How to Compare Visible Frame Widths on Ultra-Slim Windows
design guide7 min read

How to Compare Visible Frame Widths on Ultra-Slim Windows

Read the outer frame and centre junction on an elevation, then check frame depth on a section.

Updated

Which picture window will show the least frame from outside? Ask each supplier to draw the same opening from the exterior. On a fixed pane, measure from the edge of the finished wall opening to the first visible glass at the jamb. Repeat at the head and sill, where the exposed width can be different.

For sliding windows, also measure across the centre junction with the panels closed, from one visible glass edge to the other. When comparing ultra-slim window profiles, ask which of these measurements appears in the quotation. A section gives you a separate measurement, the depth of the frame through the wall.

Two exterior elevations show the exposed jamb on a fixed window and the full centre junction of a closed sliding window. A section marks the frame depth between its outside and inside faces.
The magenta marks show the two edges to measure in each schematic view. Compare quotes using dimensioned drawings of your own opening.

What to measure on minimal frame windows

Use the same drawing view and junction when comparing systems.
Detail What to look for What to request
Visible sightlineThe frame or panel junction seen when looking at the opening.An elevation identifying which junction the stated dimension describes.
Frame depthThe section extending into the opening, which is different from its visible face.A section showing the frame and its connection to the wall.
Meeting stileThe junction between adjacent panels when closed.The complete junction, including both panels and their overlap where applicable.
ThresholdThe bottom of the opening and its relationship to the finished floor.A section showing internal and external floor levels and the proposed drainage detail.

For a terrace opening, ask both suppliers to mark the centre junction on the elevation and show where the track meets the finished floor on the section. You can then compare the view from the living room and the threshold you will step over.

Start with the view and architectural rhythm

Before choosing a system, identify what the opening is meant to do for the space. Does it frame one broad landscape? Create a corner connection? Bring controlled ventilation into a bedroom? Disappear into an interior wall?

The panel arrangement should follow that purpose. Large uninterrupted glass areas usually create a calmer result than many small repeated panes. Operable panels should be placed where they support movement and ventilation without fragmenting the primary view.

The frame is only one part of the opening

Ultra-slim design depends on details that may not appear in the first rendering:

  • The relationship between internal and external floor levels
  • Drainage and waterproofing around a low or visually reduced threshold
  • The position of handles, locks, screens, motors, and access panels
  • How fixed glass aligns with sliding or casement panels
  • Where wall, ceiling, stone, timber, or joinery finishes terminate
  • How the system can be installed, adjusted, cleaned, and maintained

When these decisions happen late, the product may still function but the architecture often loses its intended clarity.

Choose the family before the final configuration

Atlas organises its main product line into three architectural families:

The final choice and configuration depend on the opening, glass, movement, hardware, interfaces, and site conditions. Atlas does not present one generic dimension or test value as applicable to every arrangement.

Questions to resolve during design

  • Which part of the opening should remain visually uninterrupted?
  • Which panels must move, and how will people use them every day?
  • Where will water go at the threshold and surrounding construction?
  • Are insect screens, automation, access control, or special hardware required?
  • What glass make-up and project-specific performance are required?
  • How will the opening coordinate with interior and exterior finishes?

Turn the design into a project brief

For a sliding opening, review the Atlas ultra-slim sliding door systems and selection steps. Keep the same opening schedule when comparing options, and use the sliding door cost guide to check which items belong in the quotation.

Share plans, elevations, opening schedules, and finish references through the Atlas project enquiry so the system can be reviewed against the real design intent.